XRP9710 Datasheet, PDF (32/36 Pages) Exar Corporation – Dual 6A Programmable Power Module

XRP9710 and XRP9711
Dual 6A Programmable Power Module
XRP9710
The XRP9710 differs from the XRP9711 in
that it eliminates the two external power
stages but adds differential voltage sensing of
the two remaining outputs. However, the two
remaining channels remain designated 3 and
4. Below in the PA 5.1 Dashboard, one can
see Channels 1 and 2 grayed out when using
a XRP9710. This methodology also ensures
code development is easily ported between
the two devices.
By clicking on the Flash button, the user will
start the programming sequence of the
design configuration into the Flash NVM. After
the programming sequence completes, the
chip will reset (if automatically reset After
Flashing box is checked) and boot the design
configuration from the Flash.
Users who wish to create their own
programming procedure so they can re-
program Flash in-circuit using their system
software should contact Exar for a list of
needed I²C Flash Commands.
© 2014 Exar Corporation
32/36
Rev. 1.0.1