XR17V252_08 Datasheet, PDF (11/69 Pages) Exar Corporation – 66 MHZ PCI BUS DUAL UART WITH POWER MANAGEMENT SUPPORT

XR17V252
REV. 1.0.2
66 MHZ PCI BUS DUAL UART WITH POWER MANAGEMENT SUPPORT
D3_COLD STATE
The V252 enters the state when power is removed from the device. All context is lost in this state and the V252
does not support PME# in this state. When power is restored, PCI RST# must be asserted and the V252 will
return to the D0 Uninitialized state with a full PCI 3.0 compliant power-on reset sequence. The V252 will set all
its registers and outputs to the power-on defaults just as at initial power up. The system software must then
fully initialize and re-configure the V252 to place it in the D0 Active state.
FIGURE 4. POWER STATE TRANSITIONS OF THE XR17V252
Power on +
PCI RST#
D0
Uninitialized
Power on +
PCI RST#
D0
Active
D3_cold
D3_hot
VCC Removed
1.3 Special Read/Write Register to store User Information
This 32-bit register can be used to store user information and is writable only via the EEPROM. This is
implemented at an offset of 0x48 in the PCI Configuration Space immediately following the Power
Management Registers. This register can be used to store application-specific information which may be used
by the device driver to initialize the device appropriately.
TABLE 3: SPECIAL READ/WRITE REGISTER
ADDRESS
OFFSET
0x48
BITS
31:0
TYPE
EWR
DESCRIPTION
User Information Writable only through EEPROM
RESET VALUE
(HEX)
0x00000000
NOTE: EWR=Read/Write from external EEPROM.
11