English
Language : 

M0519 Datasheet, PDF (8/69 Pages) List of Unclassifed Manufacturers – 32-bit Microcontroller
M0519
– Supports multiple clock sources from HCLK/2048 (default selection) and LIRC
– Window set by 6-bit counter with 11-bit prescale
– Able to wake up from Power-down or Idle mode
 Basic PWM
– 1 unit of 16-bit basic PWM, up to 2ch output
– Alternative function as input capture timer
 Enhanced PWM
– 2 units of 16-bit enhanced PWM, up to 6ch output with dead-zone control, brake and
polarity control for motor drive
– Default tri-state during any reset
 Enhanced Input Capture
– Up to 2 units of 24-bit input capture
– Each unit has 3 inputs: ECAPx_IC0, ECAPx_IC1 and ECAPx_IC2
 UART
–
–
–
–
–
–
 SPI
Up to two 16550 compatible UART devices
Programmable baud-rate generator
Buffered receiving and transmitting, each with 16 bytes FIFO
Supports flow control (TX, RX, CTS and RTS)
Supports IrDA(SIR) function
Supports RS-485
–
–
–
–
–
–
–
 I2C
Up to three sets of SPI device
Supports SPI master/slave mode
Full duplex synchronous serial data transfer
Variable length of transfer data from 8 to 32 bits
MSB or LSB first data transfer
Rx and Tx on both rising or falling edge of serial clock independently
Supports Byte Suspend mode in 32-bit transmission
– Master/Slave up to 1 Mbit/s
– Bi-directional data transfer between masters and slaves
– Multi-master bus (no central master)
– Arbitration between simultaneously transmitting masters
– Programmable clocks allow versatile rate control
– Multiple address recognition (four slave address with mask option)
 ADC
– Two A/D converters
– Each ADC with up to 8 channel, 12-bit resolution with 10-bit accuracy
– 16 result registers
– Sampling rate up to 800ksps
– Two operating modes:
 Single Sampling mode: Only one specified channel can be sampled at one time.
 Simultaneous Sampling mode: Allowing two ADC channels to be sampled
simultaneously.
– Two converting result digital comparators
– Conversion start by software, external pins, or linked with Timer 0~3 or PWM module
 Up to three Analog Comparators
 Up to two OPA (operational amplifier)
Nov. 02, 2016
Page 8 of 69
Rev 1.02