G100R3278 Datasheet, PDF (7/8 Pages) List of Unclassifed Manufacturers – Manual Wire Wrapping Tools Users Guide

3. Apply grease
to the bevel,
spur and face gear.
Reassembly:
1. Prior to closing the unit the bit index must be checked.
2. Load a bit into the barrel assembly.
3. The wire slot on the bit should be in the 12 O’clock position. If the
wire slot is not in the 12 O’clock position then proceed to step 4.
If the wire slot is in the 12 O’clock position then proceed to step 5.
4. Lift the barrel assembly from the gun assembly and rotate the bit
until the wire slot is in the 12 O’clock position. Reinstall the barrel
assembly into the gun housing. Insure the barrel-locating pin is
seated into its locating hole in the housing and that the bit is still
in the 12 O’clock position.
5. Reinstall top housing and Install the bottom 6-32x5/8 screw. Install
collet and nose piece, insuring that the colet-locating pin is seated
in the locating hole in the housing. Install remaining screws.
7