G100R3278 Datasheet, PDF (2/8 Pages) List of Unclassifed Manufacturers – Manual Wire Wrapping Tools Users Guide

BIT AND SLEEVE INSTALLATION:
1. Remove the tool from the box.
2. Install a Bit and Sleeve. Follow installation instructions below.
(Bits and Sleeves are sold separately. See page 5 for bit and sleeve
selection).
* Loosen nose piece (nut).
* Insert the bit into the nose
piece
* Rotate until the bit is
seated on the driver.
* Place sleeve over the bit
and slide the sleeve into
the nose piece. Rotate the
sleeve as you are sliding
the sleeve into the nose
piece until the sleeve has
engaged with the collet
pin, the sleeve will then
slide further into the
nose piece. The sleeve is
now seated.
2