A-4598 Datasheet, PDF (7/52 Pages) List of Unclassifed Manufacturers – Tools for Telecom, Fiber Optics, CATV, Wireless and Electronics Industries

DUAL FUNCTION
WRAP/UNWRAP BIT & SLEEVE SETS
PATENTED
DFB224 & DFB2426 DUAL FUNCTION BIT/SLEEVE SETS
This innovative Patented product represents a truly revolutionary approach to wire wrapping, by combining both the wrap
and the unwrap functions into one bit/sleeve set. The bit is precision machined for high quality wrapping in the clockwise
direction, but also includes the removal mechanism that is used to unwrap when operated counterclockwise. The user can
quickly and easily switch back and forth between wrap and unwrap mode by retracting or extending the retractable sleeve,
and flipping the switch on a wrap/unwrap power tool (i.e., a power wire wrapping tool with reversible motor). This product,
which can wrap or unwrap 22–26 AWG wire (depending on set), enables the user to maximize operating efficiency while
eliminating the need to purchase and carry extra tools or bits for unwrapping. Also, to prevent pin-to-pin shorting, the
retractable sleeve is coated with a durable 1000V dielectric material.
Note: The DFB set can only be used with the PTX or other powered wire wrapping tools with a reverse mode.
Part #
Description
Wire Size
AWG MM
Min. Terminal Max. Terminal Terminal Terminal Hole Effective
Diagonal
Diagonal
Hole Depth Diameter
Radius
IN.
MM IN.
MM IN.
MM IN.
MM IN. MM
DFB224 Wrap/Unwrap Bit/Sleeve Set 22-24 AWG 22/24 .50/.65 .054
KB-DF224 Replacement bit for DFB224
P-DF224 Replacement Sleeve for DFB224
DFB2426 Wrap/Unwrap Bit/Sleeve Set 24-26 AWG 24/26 .40/.50 .054
KB-DF2426 Replacement bit for DFB2426
P-DF2426 Replacement Sleeve for DFB2426
1.37 .073
1.37 .065
1.85 0.50 12.70 .075 1.90 .111 2.82
1.65 0.50 12.70 .066 1.67 .098 2.48
HOW TO USE THE DFB224 & DFB2426
The Wrap/Unwrap bit is shipped with the sleeve set in the wrap position. To change to the unwrap function simply
pull the sleeve out approximately 1/4” (the sleeve is spring loaded and you should feel some tension while pulling
forward), rotate the sleeve in either direction 180⁰ and release. The sleeve should now be seated approximately 1/4”
lower than in the wrap position. This will expose the unwrap feature on the bit.
To change back to the wrap position pull the sleeve out approximately 1/2” and rotate the sleeve in either direction
180⁰ and release. The spout should be in the 12:00 position and the sleeve should be locked in position.
Note: If you cannot rotate the sleeve, you need to pull the sleeve out further before trying to rotate the sleeve.
Phone: [phone] • Fax: [phone] • [e-mail]
INDUSTRIES CORP.
7