9202-S Datasheet, PDF (4/122 Pages) List of Unclassifed Manufacturers – E-Z-Hook is dedicated to providing quality parts, delivered on-time at reasonable prices

LEAD LENGTH AND CABLE LENGTH INFORMATION
E-Z-Hook offers a selection of standard length test leads, patch cords, and cable assemblies. We also offer custom
lengths to fit special requirements.
All length measurements are made in inches, see diagrams below for measuring examples:
Standard lengths in inches for test
lead and patch cord assemblies:
3" (8cm) lead wire
4" (10cm) lead wire
6" (15cm)
8" (20cm)
12" (30cm)
18" (45cm)
24" (60cm)
36" (90cm)
48" (120cm)
60" (150cm)
Standard lengths in inches
for cable assemblies:
6" (15cm) 30" (75cm)
12" (30cm) 36" (90cm)
18" (45cm) 48" (120cm)
24" (60cm) 60" (150cm)
*longer lengths available
COLOR & SET ORDERING INFORMATION
There are a many different color options when ordering E-Z-Hook parts.
Please refer to the chart to the right for set information.
Standard Colors: Black, brown, red, orange, yellow, green, blue, violet, gray,
and white.
Kilo-Colors: See inside back cover.
SETS & CUSTOM COLOR
Standard Sets:
R/B = 1 red, 1 black
S = 1 each of 10 colors
S(color)= 10 of one color
S14 = Set of 10 solid, plus 4 kilo color*
S16 = Set of 10 solid, plus 6 kilo color*
(Ex. 204-12W-S or 204-12W-R/B)
Muti-color Unit:
*Kilo-Color offers 1000 different color combination
choices. See Kilo-Color info on inside back cover.
HOW TO ORDER TEST LEADS & CABLE ASSEMBLIES
Ordering E-Z-Hook test leads and cable assemblies is E-Z. Select the part number supplied in the product section, then
select your lead or cable length and color. Example: 704XR-18-RED (Part No.-Length-Color). Variations of each hook
may be ordered in place of the standard hook. Ordering information is provided at the beginning of each section.
FIELD SERVICING INFORMATION
Most hooks are designed to be field serviceable. To replace a lead wire,
Fig.1
pull on the plunger until it slips free of the body. Strip lead wire ¾"
(19mm), feed wire through plunger and wrap around terminal as
shown in figure 1. Solder and cut off excess wire at solder point.
Reassemble part, making sure the terminal and nylon fins enter their
respective grooves. Keep slack in lead wire pulled out while assembling
to prevent binding.
NOTE: To disassemble XM Micro-Hook connectors or leads, actuate plunger to expose hook and grasp behind hook with long nose pliers
before pulling plunger off. Failure to do so will result in damage to part.
CAN’T FIND WHAT YOU’RE LOOKING FOR? NO PROBLEM!
If you cannot find what you are looking for or require precise details, please don’t hesistate to contact us. Custom is
standard at E-Z-Hook, and our Engineering Department is always happy to work with your specific needs.
CONTACTING E-Z-HOOK
For ordering, engineering, or custom questions please contact us toll free at 1-(800)-995-HOOK (4665), by fax
[phone], or reach us via e-mail at [e-mail].
1
Order Desk: 1 (800) 995-HOOK