DS_FT230X Datasheet, PDF (27/44 Pages) List of Unclassifed Manufacturers – Future Technology Devices International Ltd

7.3 USB to RS422 Converter
FT230X USB TO BASIC UART IC
Version 1.2
Document No.: FT_000566 Clearance No.: FTDI# 260
1
2
3
4
5
SHIELD
Ferrite
Bead
47pF
10nF
GND
GND
VCC
27R
27R
47pF
VCC
USBDM
USBDP
RXD
TXD
RTS#
CTS#
FT230X
RESET#
VCCIO
SLEEP#
3V3OUT
PWREN#
100nF
VCC
+ 4.7uF
GND
100nF
GND
VCCIO
Vcc
10K
Vcc
RS 422 LEVEL
4 ^CONVERTER
10
5
9
3
11
2
12
ZT3491
6
7
Vcc
RS 422 LEVEL
CONVERTER
4
10
5
9
3
11
2
12
ZT3491
6
7
RXD
TXD
RTS
CTS
GND
TXDM
TXDP
RXDP
RXDM
RTSM
RTSP
CTSP
CTSM
SHIELD
Figure 7.3 USB to RS422 Converter Configuration
An example of using the FT230X as a USB to RS422 converter is shown in Figure 7.3. In this application,
two TTL to RS422 Level Converter ICs are used on the serial UART interface of the FT230X to convert the
TTL levels of the FT230X to RS422 levels. There are many suitable level converter devices available. This
example uses Zywyn ZT3491 devices which have enables on both the transmitter and receiver. Since the
ZT3491 transmitter enable is active high, it is connected to a CBUS pin in SLEEP# configuration. The
ZT3491 receiver enable is active low and is therefore connected to a CBUS pin PWREN# configuration.
This ensures that when both the ZT3491 transmitters and receivers are enabled then the device is active,
and when the device is in USB suspend mode, the ZT3491 transmitters and receivers are disabled. If a
similar application is used, but the design is USB BUS powered, it may be necessary to use a P-Channel
logic level MOSFET (controlled by PWREN#) in the VCC line of the ZT3491 devices to ensure that the USB
standby current of 2.5mA is met.
The ZT3491 is specified to transmit and receive data at a rate of up to 16 Mbaud. In this example the
maximum data rate is limited to 3 Mbaud by the FT230X.
Copyright © 2013 Future Technology Devices International Limited
27