JH162A Datasheet, PDF (24/25 Pages) List of Unclassifed Manufacturers – SPECIFICATIONS FOR LCD MODULE

JH162A SERIES
JEWEL HILL
.) The modules should be kept in antistatic bags or other containers
resistant to static for storage.
.) Only properly grounded soldering irons should be used.
.) If an electric screw driver is used it should be well grounded and
shielded from commutator sparks.
.) The normal static prevention measures should be observed for work
clothes and working benches; for the latter conductive(rubber)mat is
recommended.
.) Since dry air is inductive to statics, a relative humidity of 50 – 60% is
recommended.
c. Soldering
.) Solder only to the I/O terminals.
.) Use only soldering irons with proper grounding and no leakage.
.) Soldering temperature is 280 10 .
.) Soldering time: 3 to 4 seconds.
.) Use eutectic solder with resin flux fill.
.) If flux is used. The LCD surface should be covered to avoid flux
spatters. Flux residue should be removed afterwards.
.) Use proper de-soldering methods(e.e. suction type desoldering irons)
to remove lead wires from the I/O terminal when necessary. Do not
repeat the soldering / desoldering process more than three times as
the pads and plated through holdes may be damaged.
21 / 22