UMFT60X Datasheet, PDF (19/24 Pages) List of Unclassifed Manufacturers – UMFT60x FIFO TO USB 3.0 Bridge Evaluation Board

UMFT60x FIFO TO USB 3.0 Bridge Evaluation Board
Version 1.0
Document Reference No.: FT_001191 Clearance No.: FTDI#457
4 Hardware Setup Guide
4.1 Power Configuration
There are 3 methods of powering the UMFT60xx module.
1) FIFO master board Power (3.3V)-Connect the UMFT60xx board to the FIFO master
board that has the standard configuration FMC (LPC or HPC) or HSMC female
connector. This method is the default setting and recommended.
2) USB Power (5V) - Connect USB power by micro-USB3.0 or micro-USB2.0 cable to CN1.
3) DC IN (5V) - Connect DC 5V to CN2.
The following table summarizes how to power the UMFT60xx module using the various methods.
Power Method
CN1 CN2
JP1
JP2
JP3 and JP6
FIFO master board
Power(Default and
-
Recommended)
USB Power
5V
DC IN(5V)
-
Follow FIFO master IO
N.C.
Open
Short pin 2-3 _voltage.
Default:
N.C. Short pin1-2 Short pin1-2
JP3 short pin1-2
VCCIO=2.5V
5V Short pin2-3 Short pin1-2
JP6: Open
Table 4.1 Board Power Configuration
4.2 Jumpers Default Position
Jumper
JP1
JP2
JP3
JP4
JP5 JP6
Default Position Open 2-3
1-2
1-2
1-2 Open
Table 4.2 Jumpers Default Position
Figure 4.1 shows the Jumpers’ locations on the PCB, and they are the same location on all 4
modules.
Figure 4-1 Jumpers Locations
Copyright © 2015 Future Technology Devices International Limited
18