PC7410 Datasheet, PDF(42/57 Page) ATMEL Corporation – PowerPC 7410 RISC Microprocessor Product Specification

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

PC7410 Datasheet, PDF (42/57 Pages) ATMEL Corporation – PowerPC 7410 RISC Microprocessor Product Specification

◁

PC7410

13. Clock Selection

The PC7410âs PLL is configured by the PLL_CFG[0:3] signals. For a given SYSCLK (bus) frequency,

the PLL configuration signals set the internal CPU and VCO frequency of operation. The PLL configura-

tion for the PC7410 is shown in Table 13-1 for example frequencies. In this example, shaded cells

represent settings that, for a given SYSCLK frequency, result in core and/or VCO frequencies that do not

comply with the minimum and maximum core frequencies listed in Table 9-3 on page 21.

Table 13-1. PC7410 Microprocessor PLL Configuration(1)(2)(3)(4)(5)

Example Bus-to-Core Frequency in MHz (VCO Frequency in MHz)

PLL_CFG

[0:3]

Bus-to-

Core

Multiplier

Core-to-

VCO

Multiplier

Bus

33.3 MHz

Bus

50 MHz

Bus

66.6 MHz

Bus

75 MHz

Bus

83.3 MHz

Bus

100 MHz

Bus

133 MHz

0100

0110

2.5x

1000

400 (800)

1110

3.5x

350 (700) 465 (930)

1010

400 (800)

0111

4.5x

375 (750) 450 (900)

1011

375 (750) 416 (833) 500 (1000)

1001

5.5x

366 (733) 412 (825) 458 (916)

1101

400 (800) 450 (900) 500 (1000)

0101

6.5x

433 (866) 488 (967)

0010

350 (700) 466 (933)

0001

7.5x

375 (750)

500

(1000)

1100

400 (800)

0000

450 (900)

0011

PLL off/bypass

PLL off, SYSCLK clocks core circuitry directly, 1x bus-to-core implied

1111

PLL off

PLL off, no core clocking occurs

Notes:

1. PLL_CFG[0:3] settings not listed are reserved.

2. The sample bus-to-core frequencies shown are for reference only. Some PLL configurations may select bus, core, or VCO

frequencies which are not useful, not supported, or not tested for by the PC7410; see âClock AC Specificationsâ on page 20

for valid SYSCLK, core, and VCO frequencies.

3. In PLL-bypass mode, the SYSCLK input signal clocks the internal processor directly, the PLL is disabled, and the bus mode

is set for 1:1 mode operation. This mode is intended for factory use and third- party emulator tool development only.

Note: The AC timing specifications given in this document do not apply in PLL-bypass mode.

4. In PLL-off mode, no clocking occurs inside the PC7410 regardless of the SYSCLK input.

5. PLL-off mode should not be used during chip power-up sequencing.

0832FâHIRELâ02/07

e2v semiconductors SAS 2007

▷