SD1210 Datasheet, PDF (34/46 Pages) List of Unclassifed Manufacturers – Dual-Interface SXGA TFT LCD Display Controller

SmartASIC, Inc.
SD1210
calibration for mode
720x400
Delay auto
15
calibration for mode
720x400
Disable auto
1
calibration for mode
640x480
Delay auto
15
calibration for mode
640x480
Disable auto
1
calibration for mode
800x600
Delay auto
15
calibration for mode
800x600
Disable auto
1
calibration for mode
832x624
Delay auto
15
calibration for mode
832x624
Disable auto
1
calibration for mode
1024x768
Delay auto
15
calibration for mode
1024x768
Disable auto
1
calibration for mode
INVALID
Delay auto
15
calibration for mode
INVALID
Bypass Sync Polarity 1
Dithering Enable
1
Frame Modulation 1
Enable
Horizontal
1
Interpolation Enable
Vertical Interpolation 1
Enable
Horizontal Rounding 1
November, 1999
Revision B
1: disable
0: enable
RW 1BH[6:0]- The number of frames need to be skipped before
1CH starting auto calibration for this mode
RW 1DH[7] Disable auto calibration for this mode:
1: disable
0: enable
RW 1DH[6:0]- The number of frames need to be skipped before
1EH starting auto calibration for this mode
RW 1FH[7] Disable auto calibration for this mode:
1: disable
0: enable
RW 1FH[6:0]- The number of frames need to be skipped before
20H starting auto calibration for this mode
RW 21H[7] Disable auto calibration for this mode:
1: disable
0: enable
RW 21H[6:0]- The number of frames need to be skipped before
22H starting auto calibration for this mode
RW 23H[7] Disable auto calibration for this mode:
1: disable
0: enable
RW 23H[6:0]- The number of frames need to be skipped before
24H starting auto calibration for this mode
RW 25H[7] Disable auto calibration for this mode:
1: disable
0: enable
RW 25[6:0]- The number of frames need to be skipped before
26H starting auto calibration for this mode
RW 27H[7] Bypass Input SYNC polarity detection (default 0):
1: bypass input SYNC polarity detection
0: detect input SYNC polarity and make them negative
polarity
RW 28H[7] Enable dithering for 6-bit panel (default 0):
1: enable dithering
0: disable dithering
*also check register Control_C[6]
RW 28H[6] Enable frame modulation for 6-bit panel (default 0):
1: enable frame modulation
0: disable frame modulation
*also check register Control_B[5] and Control_B[7]
RW 28H[5] Enable horizontal interpolation (default 0):
1: enable horizontal interpolation
0: disable horizontal interpolation
RW 28H[4] Enable vertical interpolation (default 0):
1: enable vertical interpolation
0: disable vertical interpolation
RW 28H[3] Enable horizontal rounding (default 0):
SmartASIC Confidential
34