5962-90899 Datasheet, PDF (3/27 Pages) List of Unclassifed Manufacturers – MICROCIRCUIT, MEMORY, DIGITAA, CMOS, 128K X 8 BIT FLASH EEPROM, MONOLITHIC SILICON

1.2.5 Lead finish. The lead finish is as specified in MIL-PRF-38535 for device classes Q and V or MIL-PRF-38535, appendix
A for device class M.
1.3 Absolute maximum ratings. 1/
Endurance:
Device types 01-04, 09 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10,000 cycles/byte, minimum
Device types 05-08 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1,000 cycles/byte, minimum
Device types 10-13 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100,000 cycles/byte, minimum
Supply voltage range (VCC) 2/ . .
Storage temperature range (Tstg)
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
-2.0 V
-65C
dc to +7.0 V
to +150C
dc
Maximum power dissipation (PD) . . . . . . .
Lead temperature (soldering, 10 seconds)
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
1.0 W
+300C
Junction temperature (TJ) 3/ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +150C
 Thermal resistance, junction-to-case (
 Thermal resistance, junction-to-case (
 Thermal resistance, junction-to-case (
JC)
JC)
JC)
(case
(case
(case
outline X, Y)
outlines T, Z)
outline U) . . .
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
See MIL-STD-1835
13C/W
27C/W
Voltage on any pin with respect to ground 2/ . . . . . . . . . . . . . . . . . . . . . -2.0 V dc to +7.0 V dc
Voltage on pin A9 with respect to ground 4/ . . . . . . . . . . . . . . . . . . . . . -2.0 V dc to +13.5 V dc
VPP supply voltage with respect to ground 4/ . . . . . . . . . . . . . . . . . . . . -2.0 V dc to +14.0 V dc
VCC supply voltage with respect to ground 2/ . . . . . . . . . . . . . . . . . . . . -2.0 V dc to +7.0 V dc
Output short circuit current 5/ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mA
Data retention . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 years minimum
1.4 Recommended operating conditions. 6/
Supply voltage range (VCC) . . . . . . .
Operating temperature range (Tcase)
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
+4.5 V dc to +5.5
-55C to +125C
V
dc
Low level input voltage range (VIL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 V dc to +0.8 V dc
High level input voltage range (VIH) . . . . . . . . . . . . . . . . . . . . . . . . . . . . +2.0 V dc to VCC +0.5 V dc
High level input voltage range, CMOS (VIH) . . . . . . . . . . . . . . . . . . . . . . VCC -0.5 V dc to VCC +0.5 V dc
Chip clear (VP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11.4 V dc to 12.6 V dc
1.5 Digital logic testing for device classes Q and V.
Fault coverage measurement of manufacturing
logic tests (MIL-STD-883, test method 5012) . . . . . . . . . . . . . . . . . . . . 100 percent
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ Minimum dc voltage on input or VO pins is -0.5 V. During voltage transitions, inputs may overshoot VSS to -2.0 V for
periods of up to 20 ns. Maximum dc voltage on output and VO pins is VCC +0.5 V. During voltage transitions outputs
may overshoot to VCC +2.0 V for periods up to 20 ns.
3/ Maximum junction temperature shall not be exceeded except for allowable short duration burn-in screening conditions in
accordance with method 5004 of MIL-STD-883.
4/ Minimum dc input voltage on A9 or VPP may overshoot to +14.0 V for periods less than 20 ns.
5/ No more than one output shorted at a time. Duration of short circuit should not be greater than 1 second.
6/ All voltages are referenced to VSS (ground).
STANDARD
MICROCIRCUIT DRAWING
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43216-5000
DSCC FORM 2234
APR 97
SIZE
A
REVISION LEVEL
C
5962-90899
SHEET
3