EN25T16A Datasheet, PDF (8/35 Pages) Eon Silicon Solution Inc. – 16 Megabit Uniform Sector, Serial Flash Memory

Table 3. Protected Area Sizes Sector Organization
EN25T16A
Status Register
Content
BP2 BP1 BP0
Bit Bit Bit
0
0
0
0
0
1
0
1
0
0
1
1
1
0
0
1
0
1
1
1
0
1
1
1
Memory Content
Protect Areas
None
Block 0 to 30
Block 0 to 29
Block 0 to 27
Block 0 to 23
Block 0 to 15
All
All
Addresses
None
000000h-1EFFFFh
000000h-1DFFFFh
000000h-1BFFFFh
000000h-17FFFFh
000000h-0FFFFFh
000000h-1FFFFFh
000000h-1FFFFFh
Density(KB)
None
1984KB
1920KB
1792KB
1536KB
1024KB
2048KB
2048KB
Portion
None
Lower 31/32
Lower 30/32
Lower 28/32
Lower 24/32
Lower 16/32
All
All
Hold Function
The Hold (HOLD) signal is used to pause any serial communications with the device without resetting
the clocking sequence. However, taking this signal Low does not terminate any Write Status Register,
Program or Erase cycle that is currently in progress.
To enter the Hold condition, the device must be selected, with Chip Select (CS#) Low. The Hold
condition starts on the falling edge of the Hold (HOLD) signal, provided that this coincides with Serial
Clock (CLK) being Low (as shown in Figure 4.).
The Hold condition ends on the rising edge of the Hold (HOLD) signal, provided that this coincides with
Serial Clock (CLK) being Low.
If the falling edge does not coincide with Serial Clock (CLK) being Low, the Hold condition starts after
Serial Clock (CLK) next goes Low. Similarly, if the rising edge does not coincide with Serial Clock (CLK)
being Low, the Hold condition ends after Serial Clock (CLK) next goes Low. (This is shown in Figure 4.).
During the Hold condition, the Serial Data Output (DO) is high impedance, and Serial Data Input (DI)
and Serial Clock (CLK) are Don’t Care.
Normally, the device is kept selected, with Chip Select (CS#) driven Low, for the whole duration of the
Hold condition. This is to ensure that the state of the internal logic remains unchanged from the mo-
ment of entering the Hold condition.
If Chip Select (CS#) goes High while the device is in the Hold condition, this has the effect of resetting
the internal logic of the device. To restart communication with the device, it is necessary to drive Hold
(HOLD) High, and then to drive Chip Select (CS#) Low. This prevents the device from going back to the
Hold condition.
Figure 4. Hold Condition Waveform
This Data Sheet may be revised by subsequent versions
8
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc.,
Rev. C, Issue Date: 2011/04/15
www.eonssi.com