EN25S10A Datasheet, PDF (46/64 Pages) Eon Silicon Solution Inc. – 1 Megabit 1.8V Serial Flash Memory with 4Kbyte Uniform Sector

EN25S10A
Read Identification (RDID) (9Fh)
The Read Identification (RDID) instruction allows the 8-bit manufacturer identification to be read,
followed by two bytes of device identification. The device identification indicates the memory type in the
first byte , and the memory capacity of the device in the second byte .
Any Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is not
decoded, and has no effect on the cycle that is in progress. The Read Identification (RDID) instruction
should not be issued while the device is in Deep Power down mode.
The device is first selected by driving Chip Select Low. Then, the 8-bit instruction code for the
instruction is shifted in. This is followed by the 24-bit device identification, stored in the memory, being
shifted out on Serial Data Output , each bit being shifted out during the falling edge of Serial Clock .
The instruction sequence is shown in Figure 35. The Read Identification (RDID) instruction is
terminated by driving Chip Select High at any time during data output.
When Chip Select is driven High, the device is put in the Standby Power mode. Once in the Standby
Power mode, the device waits to be selected, so that it can receive, decode and execute instructions.
The Read Identification (RDID) instruction is available in Standard SPI Mode only.
Figure 35. Read Identification (RDID)
Enter OTP Mode (3Ah)
This Flash has an extra 512 bytes OTP sector, user must issue ENTER OTP MODE command to read,
program or erase OTP sector. After entering OTP mode, the OTP sector is mapping to sector 31, SRP
bit becomes OTP_LOCK bit and can be read with RDSR command. The Chip Erase, Bank Erase, Half
Bank Erase, Suspend and Resume commands are also disabled.
In OTP mode, user can read other sectors, but program/erase other sectors only allowed when
OTP_LOCK bit equal to ‘0’.
WRSR command will ignore the input data and program OTP_LOCK bit to 1.
This Data Sheet may be revised by subsequent versions
46
or modifications due to changes in technical specifications.
©2014 Eon Silicon Solution, Inc.,
Rev. A, Issue Date: 2014/01/20
www.eonssi.com