EN25S10A Datasheet, PDF (30/64 Pages) Eon Silicon Solution Inc. – 1 Megabit 1.8V Serial Flash Memory with 4Kbyte Uniform Sector

EN25S10A
Set Burst (C0h)
The Set Burst command specifies the number of bytes to be output during a Read Bust command
before the device wraps around. To set the burst length the host driver CS# low, sends the Set Burst
command cycle (C0h) and one data cycle, then drivers CS# high. After power-up or reset, the burst
length is set to 8 bytes (00h), please refer to Table 5 for burst length data and Figure 19 for the
sequence. In QPI mode, a cycle is two nibbles, or two clocks, long, most significant nibble first.
The instruction sequence is shown in Figure 19.1 while using the Enable Quad Peripheral Interface
mode (EQPI) (38h) command.
Figure 19. Set Burst Instruction Sequence Diagram
Figure 19 Set Burst Instruction Sequence Diagram
This Data Sheet may be revised by subsequent versions
30
or modifications due to changes in technical specifications.
©2014 Eon Silicon Solution, Inc.,
Rev. A, Issue Date: 2014/01/20
www.eonssi.com