EN25P80 Datasheet, PDF (25/30 Pages) Eon Silicon Solution Inc. – 8 Mbit Uniform Sector, Serial Flash Memory

EN25P80
ABSOLUTE MAXIMUM RATINGS
Stresses above the values so mentioned above may cause permanent damage to the device. These
values are for a stress rating only and do not imply that the device should be operated at conditions up to
or above these values. Exposure of the device to the maximum rating values for extended periods of time
may adversely affect the device reliability.
Parameter
Storage Temperature
Plastic Packages
Output Short Circuit Current¹
Value
Unit
-65 to +125
°C
-65 to +125
°C
200
mA
Input and Output Voltage (with respect to
ground) ²
-0.5 to +4.0
V
Vcc
-0.5 to +4.0
V
Notes:
1. No more than one output shorted at a time. Duration of the short circuit should not be greater than one second.
2. Minimum DC voltage on input or I/O pins is –0.5 V. During voltage transitions, inputs may undershoot Vss to –1.0V for
periods of up to 50ns and to –2.0 V for periods of up to 20ns. See figure below. Maximum DC voltage on output and I/O
pins is Vcc + 0.5 V. During voltage transitions, outputs may overshoot to Vcc + 1.5 V for periods up to 20ns. See figure
below.
RECOMMENDED OPERATING RANGES ¹
Parameter
Value
Unit
Ambient Operating Temperature
Commercial Devices
0 to 70
°C
Industrial Devices
-40 to 85
Operating Supply Voltage
Vcc
Regulated: 3.0 to 3.6
V
Full: 2.7 to 3.6
Notes:
1. Recommended Operating Ranges define those limits between which the functionality of the device is guaranteed.
Vcc
+1.5V
Maximum Negative Overshoot Waveform
Maximum Positive Overshoot Waveform
This Data Sheet may be revised by subsequent versions ₂₅ ©2004 Eon Silicon Solution, Inc., www.essi.com.tw
or modifications due to changes in technical specifications.
Rev. C, Issue Date: 2006/12/25