GD25Q32 Datasheet, PDF (31/50 Pages) ELM Electronics – 3.3V Uniform Sector Dual and Quad Serial Flash

GD25Q32CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
http://www.elm-tech.com
Figure 27. Release Power-Down and Read Device ID Sequence Diagram
7.23. Read Manufacture ID/Device ID (REMS) (90H)
The Read Manufacturer/Device ID command is an alternative to the Release from Power-Down/Device ID
command that provides both the JEDEC assigned Manufacturer ID and the specific Device ID.
The command is initiated by driving the CS# pin low and shifting the command code “90H” followed by a
24-bit address (A23-A0) of 000000H. After which, the Manufacturer ID and the Device ID are shifted out on
the falling edge of SCLK with most significant bit (MSB) first as shown in Figure28. If the 24-bit address is
initially set to 000001H, the Device ID will be read first.
Figure 28. Read Manufacture ID/Device ID Sequence Diagram
50 - 31
Rev.1.0