MA17503 Datasheet, PDF (26/34 Pages) Dynex Semiconductor – Radiation Hard MIL-STD-1750A Interrupt Unit

MA17503
6.0 ABSOLUTE MAXIMUM RATINGS
Parameter
Supply Voltage
Input Voltage
Current Through Any Pin
Operating Temperature
Storage Temperature
Min
Max
-0.5
7
-0.3 V_DD+0.3
-20
+20
-55
125
-65
150
Table 8: Absolute Maximum Ratings
Units
V
V
mA
°C
°C
Note: Stresses above those listed may cause permanent
damage to the device. This is a stress rating only and
functional operation of the device at these conditions, or at
any other condition above those indicated in the operations
section of this specification, is not implied. Exposure to
absolute maximum rating conditions for extended periods
may affect device reliability.
7.0 DC ELECTRICAL CHARACTERISTICS
Symbol Parameter
Conditions
Total Dose Radiation Not
Exceeding 3x10⁵ Rad(Si)
Min Typ Max Units
V_DD
V_IHC
V_ILC
V_IHT
V_ILT
V_OHC
V_OLC
V_OHT
V_OLT
I_L
I_OZ
I_DDOP
I_DDST
Supply Voltage
CMOS Input High Voltage (Note 1)
CMOS Input Low Voltage (Note 1)
TTL Input High Voltage (Note 2)
TTL Input Low Voltage (Note 2)
CMOS Output High Voltage (Note 1)
CMOS Output Low Voltage (Note 1)
TTL Output High Voltage (Note 2)
TTL Output Low Voltage (Note 2)
Input Leakage Current (Note 3)
Output Leakage Current (Note 3)
Operating Supply Current
Static Supply Current
V_SS = 0
-
-
-
-
I_OH = -1.4mA, V_DD = 4.5V
I_OL = 2mA, V_DD = 5.5V
I_OH = -1.4mA, V_DD = 4.5V
I_OL = 2mA, V_DD = 5.5V
V_DD = 5.5V, V_IN = 0V or 5.5V
V_DD = 5.5V, V_O = 0V or 5.5V
V_DD = 5.5V,
SYNCLKN = 4MHz
V_DD = 5.5V,
SYNCLKN = 0MHz
4.5 5.0 5.5
V
V_DD-1
-
-
V
-
-
V_SS+1
V
2.0
-
-
V
-
-
0.8
V
4.0
-
-
V
-
-
0.5
V
3.5
-
-
V
-
-
0.4
V
-
-
±10 µA
-
-
±50 µA
-
5
14
mA
-
3
10
mA
Mil-Std-883, Method 5005, Subgroup 1, 2, 3.
Notes: 1. The following signals are CMOS compatible:
a) CMOS inputs: INTREN, Microcode Bus, (M04, M05, M06), HLDAKN and SYNCLK.
b) CMOS outputs: PIFN, IRN and IRDYN.
2. The following signals are TTL compatible:
a) DTIMERN, TGCLK, MPROEN, DMAPEN, EXADEN, PIOXEN, FLT7N, SYSFN, OVIN, PWRDN, INT02N,
INT08N,INT10N, INT11N, INT12N/IOI1N, INT13N, INT14N/IO12N, INT15N, DTON, DSN, M/ION, DMARN,
TCLK and MSTOPN.
b) TTL outputs: SURE, NPU, DDN, TGON, CDN, PAUSED, ILLADN, CONFIG, DMAKN and DMAE.
c) TTL I/O signal: Address/Data Bus (AD00-AD15).
3. Worst case at T_A = +125°C, guaranteed but not tested at T_A = -55°C.
Table 9: DC Electrical Characteristics
26/34