DA9061_17 Datasheet, PDF (78/82 Pages) Dialog Semiconductor – PMIC for applications requiring up to 6 A

DA9061
PMIC for applications requiring up to 6 A
Table 108: CONFIG_I (0x10E)
Field
Bit
Type
LDO_SD
7:7
R/W
INT_SD_MODE
6:6
R/W
HOST_SD_MODE
5:5
R/W
KEY_SD_MODE
WATCHDOG_SD
nONKEY_SD
NONKEY_PIN
4:4
R/W
3:3
R/W
2:2
R/W
1:0
R/W
Description
Enable switching off an LDO if an over-current is detected longer
than 200 ms.
Skip sequencer and dummy slots on shutdown from internal fault.
Skip sequencer and dummy slots on shutdown from SHUTDOWN
or nRESETREQ.
Enable power-on reset on shutdown from nONKEY.
Enable shutdown instead of power-down on watchdog timeout.
Enable shutdown via long press of nONKEY.
nONKEY function, see Section 6.11
Table 109: CONFIG_J (0x10F)
Field
Bit
Type
IF_RESET
7:7
R/W
TWOWIRE_TO
6:6
R/W
RESET_DURATION 5:4
R/W
SHUT_DELAY
KEY_DELAY
3:2
R/W
1:0
R/W
Description
Enable host interface reset via nRESETREQ pin
Enable 35 ms timeout for 2-wire interfaces
Minimum RESET mode duration:
00: 22 ms
01: 100 ms
10: 500 ms
11: 1 s
Shut down delay (+ KEY_DELAY) for nONKEY
nONKEY locking threshold
Table 110: CONFIG_K (0x110)
Field
Bit
Type
Reserved
7:5
R/W
GPIO4_PUPD
4:4
R/W
GPIO3_PUPD
3:3
R/W
GPIO2_PUPD
2:2
R/W
GPIO1_PUPD
1:1
R/W
GPIO0_PUPD
0:0
R/W
Description
Reserved
GPI: pull-down enabled
open drain GPO: pull-up enabled
GPI: pull-down enabled
open drain GPO: pull-up enabled
GPI: pull-down enabled
open drain GPO: pull-up enabled
GPI: pull-down enabled
open drain GPO: pull-up enabled
GPI: pull-down enabled
open drain GPO: pull-up enabled
Datasheet
CFR0011-120-00
Revision 3.3
78 of 82
04-Apr-2017
© 2017 Dialog Semiconductor