DRP-24V100W1NN Datasheet, PDF (9/13 Pages) Delta Electronics, Inc. – CliQ II DIN Rail Power Supply

TECHNICAL DATASHEET
CliQ II DIN Rail Power Supply
24V 91.2W 1 Phase, NEC Class 2 / DRP-24V100W1NN
Safety Instructions
 Vertical Mounting
 Horizontal Mounting
– ALWAYS switch mains of input power OFF before connecting and disconnecting the input voltage to the unit. If mains are not
turned OFF, there is risk of explosion / severe damage.
– To guarantee sufficient convection cooling, keep a distance of 50mm above and below the device as well as a lateral
distance of 5mm to other units.
– Note that the enclosure of the device can become very hot depending on the surrounding air temperature and load of the power
supply. Risk of burns!
– Only plug in and unplug connectors when power is turned off!
– DO NOT insert any objects into the unit.
– Hazardous voltages may be present for up to 5 minutes after the input mains voltage is disconnected. Do not touch the unit during
this time.
– The power supplies are built in units and must be installed in a cabinet or room (condensation free environment and indoor
location) that is relatively free of conductive contaminants.
– CAUTION: “For use in a controlled environment”.
9
All parameters are specified at 25°C ambient unless otherwise indicated.
www.DeltaPSU.com (January 2014, Rev. 00)