DRP-24V100W1NN Datasheet, PDF (8/13 Pages) Delta Electronics, Inc. – CliQ II DIN Rail Power Supply

TECHNICAL DATASHEET
CliQ II DIN Rail Power Supply
24V 91.2W 1 Phase, NEC Class 2 / DRP-24V100W1NN
Output De-rating VS. Input Voltage
 No output power de-rating across the entire
input voltage range
Assembly & Installation
The power supply unit (PSU) can be mounted on 35mm DIN rails in accordance with EN 60715. For Vertical Mounting, the device
should be installed with input terminal block on the bottom. For Horizontal Mounting, the device should be installed with input terminal
block on the left side.
Each device is delivered ready to install.
Mounting
Dismounting
Fig. 2.1 Mounting
Snap on the DIN rail as shown in Fig. 2.1:
1. Tilt the unit upwards and insert it onto the DIN rail.
2. Push downwards until stopped.
3. Press against the bottom front side for locking.
4. Shake the unit slightly to ensure that it is secured.
Fig. 2.2 Dismounting
To uninstall, pull or slide down the latch with screw driver as
shown in Fig. 2.2. Then slide the power supply unit (PSU) in
the opposite direction, release the latch and pull out the power
supply unit (PSU) from the rail.
In accordance to EN 60950 / UL 50950, flexible cables require ferrules.
Use appropriate copper cables designed to sustain operating temperature of:
1. 60°C, 60°C / 75°C for USA
2. At least 75°C for ambient not exceeding 60°C, and 90°C for ambient exceeding 60°C for Canada.
8
All parameters are specified at 25°C ambient unless otherwise indicated.
www.DeltaPSU.com (January 2014, Rev. 00)