English
Language : 

DRP024V060W1BX Datasheet, PDF (10/15 Pages) Delta Electronics, Inc. – Universal AC input voltage range
TECHNICAL DATASHEET
CliQ II DIN Rail Power Supply
24V 60W 1 Phase / DRP024V060W1B□
Safety Instructions
 Vertical Mounting
 Horizontal Mounting
• ALWAYS switch mains of input power OFF before connecting and disconnecting the input voltage to the unit. If mains are not
turned OFF, there is risk of explosion / severe damage.
• To guarantee sufficient convection cooling, please refer to the following instructions to ensure sufficient clearance
around the device.
Vertical Mounting: 50mm (1.97 inch) above and below the device as well as a lateral distance of 20mm (0.79 inch) to other
units.
Horizontal Mounting: 50mm (1.97 inch) above and below the device as well as a lateral distance of 50mm (1.97 inch) to
other units.
• Note that the enclosure of the device can become very hot depending on the surrounding air temperature and load of the power
supply. Risk of burns!
• Only plug in and unplug connectors when power is turned off!
• DO NOT insert any objects into the unit.
• Hazardous voltages may be present for up to 5 minutes after the input mains voltage is disconnected. Do not touch the unit during
this time.
• The power supplies are built in units and must be installed in a cabinet or room (condensation free environment and indoor
location) that is relatively free of conductive contaminants.
• CAUTION: “For use in a controlled environment”.
For DRP024V060W1BA:
• The power supplies unit must be installed in an IP54 enclosure or cabinet in the final installation. The enclosure or cabinet must
comply with EN 60079-0 or EN 60079-15.
• Warning: Explosion Hazard - Substitution of components may impair suitability for Class I, Division 2.
• Warning: Explosion Hazard - Do not disconnect equipment or adjust potentiometer unless the power has been switched off or the
area is known to be non-hazardous.
10
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (December 2016, Rev. 06)