English
Language : 

STAR1000_11 Datasheet, PDF (20/24 Pages) Cypress Semiconductor – 1M Pixel Radiation Hard CMOS Image Sensor
STAR1000
Handling Precautions
For proper handling and storage conditions, refer to the Cypress
application note AN52561, Image Sensor Handling and Best
Practices at www.cypress.com.
Limited Warranty
Cypress’s Image Sensor Business Unit warrants that the image
sensor products to be delivered hereunder, if properly used and
serviced, will conform to Seller's published specifications and will
be free from defects in material and workmanship for one (1)
year following the date of shipment. If a defect were to manifest
itself within 1 (one) year period from the sale date, Cypress will
either replace the product or give credit for the product.
Ordering Code Definition
Return Material Authorization (RMA)
Cypress packages all of its image sensor products in a clean
room environment under strict handling procedures and ships all
image sensor products in ESD-safe, clean-room-approved
shipping containers. Products returned to Cypress for failure
analysis should be handled under these same conditions and
packed in its original packing materials, or the customer may be
liable for the product.
Cypress Prefix
I=Image Sensors
STAR
S=Standard Process
M=Mono
CY I S1 S M 1000 AA - H H C S
S=Space Qualified, ES: Engg
Commercial Temperature range
H=BK7G16 Glass
Package: H= JLCC
Functionality Placeholder
1.0 MegaPixel
RoHS (Pb-free) Compliance
This paragraph reports the use of hazardous chemical substances as required by the RoHS Directive (excluding packing material).
Table 10. Chemical Substances in STAR250 Sensor
Chemical Substance
Any intentional content
If there is any intentional content, in which portion is
it contained?
Lead
NO
-
Cadmium
NO
-
Mercury
NO
-
Hexavalent chromium
NO
-
PBB (Polybrominated biphenyls)
NO
-
PBDE (Polybrominated diphenyl ethers)
NO
-
Information on Pb-Free Soldering
The product cannot withstand a Pb-free soldering process.
Reflow or wave soldering is not recommended. Hand soldering
is needed for this part type. Solder one pin on each side and let
the sensor cool down for minimum 1 minute before continuing.
Note: "Intentional Content" is defined as any material
demanding special attention that is contained into the inquired
product by these cases:
1. A case that the above material is added as a chemical compo-
sition into the inquired product intentionally to produce and
maintain the required performance and function of the
intended product
2. A case that the above material, which is used intentionally in
the manufacturing process, is contained in or adhered to the
inquired product.
The following case is not treated as "intentional content":
A case that the above material is contained as an impurity into
raw materials or parts of the intended product. The impurity is
defined as a substance that cannot be removed industrially, or it
is produced at a process like chemical composing or reaction
and it cannot be removed technically.
Document Number: 38-05714 Rev. *F
Page 20 of 24
[+] Feedback