|
BCM89071A1CUBXGT Datasheet, PDF (12/69 Pages) Cypress Semiconductor – Single-Chip Automotive Grade Bluetooth Transceiver and Baseband Processor | |||
|
◁ |
BCM89071 Data Sheet
Block Diagram
â Maximum UART baud rates of 4 Mbps
â Low-power out-of-band BT_WAKE and HOST_WAKE signaling
â VSC from host transport to UART
â Proprietary compressing scheme (allows more than two simultaneous A2DP packets and up to five
devices at a time)
⢠Channel Quality-Driven Data Rate (CQDDR) and packet type selection
⢠Standard Bluetooth test modes
⢠Extended radio and production test mode features
⢠Full support for power savings modes:
â Bluetooth standard Hold and Sniff
â Deep sleep modes and regulator shutdown
⢠Supports Wide-Band Speech (WBS) over PCM and Packet Loss Concealment (PLC) for better audio
quality
⢠2-, 3-, and 4-wire coexistence
⢠Power Amplifier (PA) shutdown for externally controlled coexistence, such as WIMAX
⢠Built-in LPO clock or operation using an external LPO clock
⢠TCXO input and auto-detection of all standard handset clock frequencies (supports low-power crystal,
which can be used during Power Saving mode with better timing accuracy)
⢠OR gate for combining a host clock request with a Bluetooth clock request (operates even when the
Bluetooth core logic is powered off)
⢠Larger patch RAM space to support future enhancements
⢠Serial flash Interface with native support for devices from several manufacturers
⢠One-Time Programmable (OTP) memory
Block Diagram
Figure 2 on page 12 shows the interconnect of the major BCM89071 physical blocks and associated external
interfaces.
Broadcom®
April 16, 2015 ⢠89071-DS106-R
Baseband Transceiver and Baseband Processor
Page 11
|
▷ |