SM3 Datasheet, PDF (34/36 Pages) Connor-Winfield Corporation – ULTRA MINIATURE STRATUM 3 MODULE

Figure 15
Optional Programing Header Reference Design
GND
J2
1
3
5
7
9
11
13
15
17
19
21
23
25
NC
NC
NC
GND
GND
GND
NC
NC
GND
GND
NC
NC
NC
VDDP
VDDP
VPP
VPN
GND
TCK
TDI
TDO
TMS
RCK
TRST
VDD
VDD
2
4
6
8
10
12
14
16
18
20
22
24
26
FTSH-113-01-L-D-K
SAMTEC
4.7uF
C5
VPP
VPN
GND
TCK
TDO
TDI
TMS
TRST
4.7uF
C6
4.7uF (low ESR, <1W, Tantalum,
25V or greater rating)
*Not required if header
is not installed.
VCC
The programming header is optional. It provides a means
for re-programming the chip on board if necessary.
The SAMTEC header has a notch and should be laid out in
such a way that the notch is on the pin1 side. The
header specified here is a thru-hole part and surface
mount versions are available. Please refer to
www.samtec.com for more information on the header.
Ordering Information
SM3-XXX.XXM
Replace XXX.XX with one of the following available frequencies,
012.96MHz, 019.44MHz, 025.92MHz, 038.88MHz, 051.84MHz or 077.76MHz.
Please contact Connor-Winfield for other frequencies that may be available.
Similar Products from Connor-Winfield
SM3-8R-XXX.XXM - Stratum 3 module with 8 input references.
SM3-IT-XXX.XXM - Industrial temperature rated Stratum 3 module with 4 input references.
SM3E-XXX.XXM - Stratum 3E module with 8 input references.
Data Sheet #: TM052 Page 34 of 36 Rev: 03 Date: 11/07/08
© Copyright 2008 The Connor-Winfield Corp. All Rights Reserved Specifications subject to change without notice