DB829 Datasheet, PDF (13/29 Pages) CML Microcircuits – Low Voltage Operation

Baseband Signal Processor
13
MX829 PRELIMINARY INFORMATION
5.2.7 MOD LEVELS Register (Hex address $12)
The six least significant bits of the first byte in this register are used to set the attenuation of the Modulator 1 amplifier and
the five least significant bits of the second byte in this register are used to set the attenuation of the Modulator 2 amplifier,
according to the tables below:
543210
0XXXXX
100000
100001
100010
100011
100100
100101
100110
100111
101000
101001
101010
101011
101100
101101
101110
101111
110000
110001
110010
110011
110100
110101
110110
110111
111000
111001
111010
111011
111100
111101
111110
111111
X = don't care
Mod. 1 Attenuation
Disabled (V_BIAS)
>40dB
12.0dB
11.6dB
11.2dB
10.8dB
10.4dB
10.0dB
9.6dB
9.2dB
8.8dB
8.4dB
8.0dB
7.6dB
7.2dB
6.8dB
6.4dB
6.0dB
5.6dB
5.2dB
4.8dB
4.4dB
4.0dB
3.6dB
3.2dB
2.8dB
2.4dB
2.0dB
1.6dB
1.2dB
0.8dB
0.4dB
0dB
43210
00000
00001
00010
00011
00100
00101
00110
00111
01000
01001
01010
01011
01100
01101
01110
01111
10000
10001
10010
10011
10100
10101
10110
10111
11000
11001
11010
11011
11100
11101
11110
11111
Mod. 2 Attenuation
>40dB
6.0dB
5.8dB
5.6dB
5.4dB
5.2dB
5.0dB
4.8dB
4.6dB
4.4dB
4.2dB
4.0dB
3.8dB
3.6dB
3.4dB
3.2dB
3.0dB
2.8dB
2.6dB
2.4dB
2.2dB
2.0dB
1.8dB
1.6dB
1.4dB
1.2dB
1.0dB
0.8dB
0.6dB
0.4dB
0.2dB
0dB
MOD1 ENABLE
(Bit 5, first byte)
When this bit is "1" the MOD1 attenuator is enabled.
When this bit is "0" the MOD1 attenuator is disabled (i.e. powersaved).
Bits 6 and 7 in the first byte and bits 5, 6 and 7 in the second byte should always be set to "0". MOD
LEVELS (1) register is loaded first.
Note: The MOD2 attenuator is enabled by the AMP2 ENABLE signal (bit 6 of CONTROL1 register).
© 1998 MX•COM Inc.
www.mxcom.com Tele: 800 638-5577 336 744-5050 Fax: [phone]
Doc. # 20480160.004
4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA
All trademarks and service marks are held by their respective companies.