CS42436_06 Datasheet, PDF (36/62 Pages) Cirrus Logic – 108 dB, 192 kHz 6-in, 6-out TDM CODEC

CS42436
CS
CCLK
C D IN
C H IP
ADDRESS
1001111
MAP
DATA
R/W
MSB
LSB
b yte 1 byte n
C H IP
ADDRESS
1001111 _R/W
CDOUT
High Impedance
MSB
LSB MSB
LSB
MAP = Memory Address Pointer, 8 bits, MSB first
Figure 17. Control Port Timing in SPI Mode
5.7.2
I²C Mode
In I²C Mode, SDA is a bidirectional data line. Data is clocked into and out of the part by the clock, SCL.
There is no CS pin. Pins AD0 and AD1 form the two least-significant bits of the chip address and should
be connected through a resistor to VLC or DGND as desired. The state of the pins is sensed while the
CS42436 is being reset.
The signal timings for a read and write cycle are shown in Figure 18 and Figure 19. A Start condition is
defined as a falling transition of SDA while the clock is high. A Stop condition is a rising transition while
the clock is high. All other transitions of SDA occur while the clock is low. The first byte sent to the
CS42436 after a Start condition consists of a 7-bit chip address field and a R/W bit (high for a read, low
for a write). The upper 5 bits of the 7-bit address field are fixed at 10010. To communicate with a CS42436,
the chip address field, which is the first byte sent to the CS42436, should match 10010 followed by the
settings of the AD1 and AD0. The eighth bit of the address is the R/W bit. If the operation is a write, the
next byte is the Memory Address Pointer (MAP) which selects the register to be read or written. If the op-
eration is a read, the contents of the register pointed to by the MAP will be output. Setting the auto-incre-
ment bit in MAP allows successive reads or writes of consecutive registers. Each byte is separated by an
acknowledge bit. The ACK bit is output from the CS42436 after each input byte is read, and is input to the
CS42436 from the microcontroller after each transmitted byte.
SCL
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 24 25 26 27 28
CHIP ADDRESS (WRITE)
MAP BYTE
DATA
DATA +1
SDA
1 0 0 1 0 AD1 AD0 0
INCR 6 5 4 3 2 1 0
7 6 10
7 6 10
ACK
ACK
ACK
START
Figure 18. Control Port Timing, I²C Write
DATA +n
76 10
ACK
STOP
36
DS647F1