CS4360_04 Datasheet, PDF (28/37 Pages) Cirrus Logic – 24-Bit, 192 kHz 6 Channel D/A Converter

CS4360
4.9.3a SPI Write
To write to the device, follow the procedure below while adhering to the control port Switching Specifica-
tions in section 3.
1) Bring CS low.
2) The address byte on the CDIN pin must then be 00100000.
3) Write to the memory address pointer, MAP. This byte points to the register to be written.
4) Write the desired data to the register pointed to by the MAP.
5) If the INCR bit (see section 4.9.1a) is set to 1, repeat the previous step until all the desired registers
are written, then bring CS high.
6) If the INCR bit is set to 0 and further SPI writes to other registers are desired, it is necessary to bring
CS high, and repeat the procedure detailed from step 1. If no further writes to other registers are de-
sired, bring CS high.
CS
CCLK
C D IN
CHIP
ADDRESS
0010000
MAP
DATA
R/W
MSB
LSB
byte 1 byte n
M A P = M e m o ry Ad dre ss P o in te r
Figure 21. SPI Write
28
DS517F2