CAT24FC64 Datasheet, PDF (6/10 Pages) Catalyst Semiconductor – 64K-Bit I2C Serial CMOS EEPROM

CAT24FC64
data. If no acknowledge is sent by the Master, the device
terminates data transmission and waits for a STOP
condition.
WRITE OPERATIONS
Byte Write
In the Byte Write mode, the Master device sends the
START condition and the slave address information
(with the R/W bit set to zero) to the Slave device. After
the Slave generates an acknowledge, the Master sends
two 8-bit address words that are to be written into the
address pointers of the CAT24FC64. After receiving
another acknowledge from the Slave, the Master device
transmits the data to be written into the addressed
memory location. The CAT24FC64 acknowledges once
more and the Master generates the STOP condition. At
this time, the device begins an internal programming
cycle to nonvolatile memory. While the cycle is in
progress, the device will not respond to any request from
the Master device.
Page Write
The CAT24FC64 writes up to 64 bytes of data, in a single
write cycle, using the Page Write operation. The page
write operation is initiated in the same manner as the
byte write operation, however instead of terminating
after the initial byte is transmitted, the Master is allowed
to send up to 63 additional bytes. After each byte has
been transmitted, CAT24FC64 will respond with an
acknowledge, and internally increment the six low order
address bits by one. The high order bits remain un-
changed.
If the Master transmits more than 64 bytes before sending
the STOP condition, the address counter ‘wraps around’,
and previously transmitted data will be overwritten.
When all 64 bytes are received, and the STOP condition
has been sent by the Master, the internal programming
cycle begins. At this point, all received data is written to
the CAT24FC64 in a single write cycle.
Acknowledge Polling
Disabling of the inputs can be used to take advantage of
the typical write cycle time. Once the stop condition is
issued to indicate the end of the host's write operation,
CAT24FC64 initiates the internal write cycle. ACK poll-
ing can be initiated immediately. This involves issuing
the start condition followed by the slave address for a
write operation. If CAT24FC64 is still busy with the write
operation, no ACK will be returned. If
CAT24FC64 has completed the write operation, an ACK
will be returned and the host can then proceed with the
next read or write operation.
WRITE PROTECTION
The Write Protection feature allows the user to protect
against inadvertent programming of the memory array.
If the WP pin is tied to V_CC, the entire memory array is
protected and becomes read only. The CAT24FC64 will
accept both slave and byte addresses, but the memory
location accessed is protected from programming by the
device’s failure to send an acknowledge after the first
byte of data is received.
Figure 6. Byte Write Timing
S
T
BUS ACTIVITY: ^A SLAVE
MASTER ^R ADDRESS
T
BYTE ADDRESS
A15–A8
A7–A0
S
T
DATA
O
P
SDA LINE S
*^{=Don't Care Bit}
***
A
A
C
C
K
K
P
A
A
C
C
K
K
Figure 7. Page Write Timing
S
T
BUS ACTIVITY: ^A SLAVE
MASTER ^R ADDRESS
T
BYTE ADDRESS
A15–A8
A7–A0
DATA
DATA n
S
T
DATA n+63
O
P
SDA LINE S
***
A
A
C
C
K
K
P
A
A
AA
A
C
C
CC
C
K
K
KK
K
*^{=Don't Care Bit}
Doc. No. 1046, Rev. G
6