CS42528 Datasheet, PDF (32/91 Pages) Cirrus Logic – 114 dB, 192 kHz 8-Ch Codec with S/PDIF Receiver

CS42528
4.6.3 ADCIN1/ADCIN2 Serial Data Format
The two serial data lines which interface to the optional external ADCs, ADCIN1 and ADCIN2, support
only left-justified, 24-bit samples at 64Fs or 128Fs. This interface is not affected by any of the serial port
configuration register bit settings. These serial data lines are used when supporting One Line Mode of
operation with external ADCs attached. If these signals are not being used, they should be tied together
and wired to GND via a pull-down resistor.
CX_LRCK
SAI_LRCK
CX_SCLK
SAI_SCLK
ADCIN1/2
Left Channel
MSB -1 -2 -3 -4 -5 +5 +4 +3 +2 +1 LSB
Right Channel
MSB -1 -2 -3 -4 +5 +4 +3 +2 +1 LSB
Left Justified Mode, Data Valid on Rising Edge of SCLK
Bits/Sample
SCLK Rate(s)
Notes
24
64, 128 Fs
single-speed mode, Fs= 32, 44.1, 48 kHz
64 Fs
double-speed mode, Fs= 64, 88.2, 96 kHz
not supported
quad-speed mode, Fs= 176.4, 192 kHz
Figure 15. ADCIN1/ADCIN2 Serial Audio Format
For proper operation, the CS42528 must be configured to select which SCLK/LRCK is being used to clock
the external ADCs. The EXT ADC SCLK bit in register “Misc Control (address 05h)” on page 52, must be
set accordingly. Set this bit to ‘1’ if the external ADCs are wired using the CODEC_SP clocks. If the ADCs
are wired to use the SAI_SP clocks, set this bit to ‘0’.
32
DS586PP5