CS4365 Datasheet, PDF (26/51 Pages) Cirrus Logic – 114 dB, 192 kHz 6-Channel D/A Converter

CS4365
3.7 ATAPI Specification
The CS4365 implements the channel mixing functions of the ATAPI CD-ROM specification. The
ATAPI functions are applied per A-B pair. Refer to Table 9 on page 42 and Figure 19 for additional informa-
tion.
Left Channel
Audio Data
A Channel
Volume
Control
MUTE _{Aout Ax}
SDINx
Σ
Σ
Right Channel
Audio Data
B Channel
Volume
Control
MUTE _AoutBx
Figure 19. ATAPI Block Diagram (x = channel pair 1, 2, or 3)
3.8 Direct Stream Digital (DSD) Mode
In software mode the DSD/PCM bits (Reg. 02h) are used to configure the device for DSD mode. The DSD_DIF bits
(Reg 04h) then control the expected DSD rate and MCLK ratio.
The DIR_DSD bit (Reg 04h) selects between two proprietary methods for DSD to analog conversion. The first
method uses a decimation free DSD processing technique which allows for features such as matched PCM level
output, DSD volume control, and 50kHz on chip filter. The second method sends the DSD data directly to the on-
chip switched-capacitor filter for conversion (without the above mentioned features).
The DSD_PM_EN bit (Reg. 04h) selects Phase Modulation (data plus data inverted) as the style of data input. In
this mode the DSD_PM_mode bit selects whether a 128Fs or 64x clock is used for phase modulated 64x data (see
Figure 20). Use of phase modulation mode may not directly effect the performance of the CS4365, but may lower
the sensitivity to board level routing of the DSD data signals.
The CS4365 can detect errors in the DSD data which does not comply with the SACD specification. The
STATIC_DSD and INVALID_DSD bits (Reg. 04h) allow the CS4365 to alter the incoming invalid DSD data.
Depending on the error, the data may either be attenuated or replaced with a muted DSD signal (the MUTEC pins
would be set according to the DAMUTE bit (Reg. 08h)).
More information for any of these register bits can be found in the “Parameter Definitions” on page 45.
The DSD input structure and analog outputs are designed to handle a nominal 0 dB-SACD (50% modulation index)
at full rated performance. Signals of +3 dB-SACD may be applied for brief periods of time however, performance at
these levels is not guaranteed. If sustained +3 dB-SACD levels are required, the digital volume control should be
26
DS670PP1