CS4364 Datasheet, PDF (25/50 Pages) Cirrus Logic – 103 dB, 192 kHz 6-Channel D/A Converter

CS4364
3.6 De-Emphasis
The CS4364 includes on-chip digital de-emphasis filters. The de-emphasis feature is included to accommo-
date older audio recordings that utilize pre-emphasis equalization as a means of noise reduction. Figure 18
shows the de-emphasis curve. The frequency response of the de-emphasis curve will scale proportionally
with changes in sample rate, Fs if the input sample rate does not match the coefficient which has been se-
lected.
In software mode the required de-emphasis filter coefficients for 32 kHz, 44.1 kHz, or 48 kHz are selected
via the de-emphasis control bits.
In hardware mode only the 44.1 kHz coefficient is available (enabled through the M2 pin). If the input sample
rate is not 44.1 kHz and de-emphasis has been selected then the corner frequencies of the de-emphasis
filter will be scaled by a factor of the actual Fs over 44,100.
Gain
dB
T1=50 µs
0dB
-10dB
T2 = 15 µs
F1
3.183 kHz
F2 Frequency
10.61 kHz
Figure 18. De-Emphasis Curve
3.7 ATAPI Specification
The CS4364 implements the channel mixing functions of the ATAPI CD-ROM specification. The
ATAPI functions are applied per A-B pair. Refer to Table 9 on page 41 and Figure 19 for additional informa-
tion.
Left Channel
Audio Data
A Channel
Volume
Control
MUTE _{Aout Ax}
SDINx
Σ
Σ
Right Channel
Audio Data
B Channel
Volume
Control
MUTE _AoutBx
Figure 19. ATAPI Block Diagram (x = channel pair 1, 2, or 3)
DS619A1
25