G2PW1V260 Datasheet, PDF (4/8 Pages) Bel Fuse Inc. – PISCES II DC/DC CONVERTERS

POWER PRODUCTS
G2PW1V260
PISCES II DC/DC CONVERTERS
48V Input – 1.2VDC – 60A Output
Application Notes
CoolConverter^™
Bel Power’s Proprietary CoolConverter™
• Patented single-stage power conversion architecture,
control and magnetic design allow unprecedented
power density and efficiency in an isolated power
supply.
• An advanced microcontroller reduces parts count while
adding features, performance and flexibility in the design.
• Low common-mode noise results from lower capacitance
in the transformer from balanced winding design.
Protection and Control
Valid Input Voltage Range
The converter measures the input voltage and will not allow
operation outside of the input voltage specification. As
shown by the graphs, hysteresis is added to both the high
and low voltage to prevent the converter from turning on and
off repeatedly when the voltage is held near either voltage
extreme. At low line, this assures the maximum input current
is not exceeded; at high line, this assures the semiconductor
devices in the converter are not damaged by excessive
voltage stress.
ON/OFF Logic Option
The ON/OFF control logic can be either Negative (standard)
or Positive to enable the converter. For Negative logic, the
ON/OFF pin is brought to below 1.0V with respect to the
–INPUT pin to enable the converter. The pull-down must be
able to sink 100µA. For Positive logic, the ON/OFF pin is
brought to greater than 4.0V with respect to the –INPUT pin
and be limited to less than 10V. To request the Positive logic
version, add the suffix (P) to the standard part number. The
ON/OFF pin has a built-in pull-up resistor of approximately
100kΩ to +5V.
Output Over Voltage Protection
The output voltage is constantly monitored by the
microprocessor with a redundant secondary-side
measurement circuit that both shuts down the duty cycle and
triggers the microprocessor to shut down. If the output voltage
exceeds the over voltage specification, the microprocessor
will latch the converter off. To turn the converter on required
either cycling the ON/OFF pin or power to the converter. This
advanced feature prevents the converter from damaging the
load if there is a converter failure or application error. If non-
latching is required, consult factory.
Over Voltage Hysteresis
6
5
4
3
2
1
0
76.5 77 77.5 78 78.5 79 79.5 80 80.5
Input Voltage (V)
Under Voltage Hysteresis
6
5
4
3
2
1
0
30 31 32 33 34 35 36 37
Input Voltage (V)
©2006 Bel Fuse Inc. Specifications subject to change without notice. 11.06
Bel Power Inc. 155 Flanders Road, Westborough, MA 01581 • Tel [phone] • Fax [phone] • www.belpower.com
page 4