HDSP-2533 Datasheet, PDF (4/15 Pages) AVAGO TECHNOLOGIES LIMITED – Eight Character 5 mm Smart Alphanumeric Display

Recommended Operating Conditions
Parameter
Symbol Minimum
Supply Voltage V_DD
4.5
Nominal
5.0
Maximum Units
5.5
V
Electrical Characteristics over Operating Temperature Range
4.5 < V_DD < 5.5 unless otherwise specified

Parameter
Symbol Min.
25°C 25°C
Typ.^[1] Max.^[1] Max.
Units Test Conditions
Input Leakage
(Input without Pull-up)
Input Current
(Input with Pull-up)
I_I
-1.0
1.0
mA
V_IN = 0 to V_DD, Pins CLK,
D₀-D₇, A₀-A₄
I_IP
-30
-11
-18
0
mA
V_IN = 0 to V_DD, Pins CLS,
RST, WR, RD, CE, FL
I_DD Blank
I_DD 8 Digits 12 Dots/Char^[2,3,4]
(AlGaAs)
I_DD(BL)
I_DD(V)
0.5
3.0
4.0
230
295
390
mA
V_IN = V_DD
mA “V” On in All 8 Locations
I_DD 8 Digits 20 Dots/Char^[2,3,4]
(AlGaAs)
I_DD(#)
330
410
480
mA “#” On in All 8 Locations
I_DD 8 Digits 12 Dots/Char^[2,3,4]
(All Colors Except AlGaAs)
I_DD(V)
200
255
330
mA “V” On in All 8 Locations
I_DD 8 Digits 20 Dots/Char^[2,3,4]
(All Colors Except AlGaAs)
I_DD(#)
300
370
430
mA “#” On in All 8 Locations
Input Voltage High
V_IH
2.0
V_DD
V
+0.3 V
Input Voltage Low
V_IL
GND
-0.3 V
0.8
V
Output Voltage High
V_OH
2.4
V
V_DD = 4.5 V, I_OH = -40 µA
Output Voltage Low D₀-D₇
V_OL
Output Voltage Low CLK
V_OL
Thermal Resistance IC
Rq_J-PIN
16
Junction-to-PIN
0.4
V
V_DD = 4.5 V, I_OL = 1.6 mA
0.4
V
V_DD = 4.5 V, I_OL = 40 µA
°C/W Measured at Pin 17
Notes:
1.  V_DD = 5.0 V.
2.  See Thermal Considerations Section for information about operation in high temperature ambients.
3.  Average I_DD measured at full brightness. See Table 2 in Control Word Section for I_DD at lower brightness levels. Peak I_DD = 28/15 x I_DD(#).
4.  Maximum I_DD occurs at -55°C.