HCPL-M454 Datasheet, PDF (1/12 Pages) Agilent(Hewlett-Packard) – Ultra High CMR, Small Outline, 5 Lead, High Speed Optocoupler

HCPL-M454
Ultra High CMR, Small Outline, 5 Lead, High Speed Optocoupler
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The HCPL-M454 is similar to Avago’s other high speed
transis­tor output optocouplers, but with shorter propa-
gation delays and higher CTR. The HCPL-M454 also has
a guaranteed propaga­tion delay difference (t_PLH - t_PHL).
These features make the HCPL-M454 an excellent solu-
tion to IPM inverter dead time and other switching prob-
lems.
The HCPL-M454 CTR, propa­ga­tion delays, and CMR are
specified both for TTL load and drive conditions and for
IPM (Intelligent Power Module) load and drive condi-
tions. Specifica­tions and typical performance plots for
both TTL and IPM conditions are provided for ease of ap-
plication.
This diode-transistor opto­coupler uses an insulating lay-
er between the light emitting diode and an integrated
photon detector to provide electrical insulation between
input and output. Separate connections for the photo-
diode bias and output transistor collector increase the
speed up to a hundred times over that of a conventional
Applications
• Inverter Circuits and Intelligent Power Module
(IPM) Interfacing: Shorter propa­gation delays and
guaranteed (t_PLH - t_PHL) specifications. (See power
inverter dead time section)
• High speed logic ground isolation: TTL/TTL, TTL/LTTL,
TTL/CMOS, TTL/LSTTL
• Line Receivers: High com­­mon mode transient
immunity (>15 kV/µs for a TTL load/drive) and low
input-output capacitance (0.6 pF)
• Replace pulse trans­formers: ave board space and
weight
• Analog signal ground isolation: Integrated
photon detector provides improved linearity over
phototransistors
Features
• Function compatible with HCPL-4504
• Surface mountable
• Very small, low profile JEDEC registered package
outline
• Compatible with infrared vapor phase reflow and
wave soldering processes
• Short propagation delays for TTL and IPM
applications
• Very high common mode transient immunity:
Guaranteed 15 kV/µs at V_CM = 1500 V
• High CTR: >25% at 25°C
• Guaranteed specifications for common IPM
applications
• TTL compatible
• Guaranteed ac and dc performance over
temperature: 0°C to 70°C
• Open collector output
• Safety approval:
UL Recognized 3750 Vac / 1 min. per UL 1577
IEC/EN/DIN EN 60747-5-2
Approved V_IORM = 560 Vpeak for Option 060.
CSA Approved
• Lead free option “-000E”
CAUTION: The small junction sizes inherent to the design of this bipolar component increase the component's suscep­ti­bility to
damage from electrostatic discharge (ESD). It is advised that normal static precautions be taken in handling and assembly of this
component to prevent damage and/or degradation which may be induced by ESD.