|
AT91SAM9XE128_1 Datasheet, PDF (854/866 Pages) ATMEL Corporation – AT91 ARM Thumb Microcontrollers | |||
|
◁ |
Doc.
Rev
6254B
Comments (Continued)
Change
Request
Ref.
SMC:
Section 23.8.5 âCoding Timing Parametersâ, âEffective Valueâ column under âPermitted Rangeâ updated in
Table 23-4 on page 211.
Section 23.9.3.1 âUser Procedureâ, instructions regarding configuration parameters of SMC Chip Select
added.
TWI:
Section 33.5.1 âI/O Linesâ, TWD and TWCK open drain status and condition updated.
Programmer interdiction added to TWD and TWCK.
Section 33.10.6 âTWI Status Registerâ, GACC bit description updated.
USART:
Manchester Encoding/Decoding is available in this implementation of the USART (not visible in 6254A).
5604
5621
5343
rfo
5773
5930
Electrical Characteristics:
Table 43-11, â32 kHz Oscillator Characteristicsâ
Table 43-15, âMain Oscillator Characteristicsâ, updated Typ values for CLEXT,
updated Startup Time parameter, VDDPLL = 1.65V to 1.95V.
Section 43.6 âADCâ, section added to datasheet
Table 43-2, âDC Characteristicsâ, VVDDIOM Condition column cleared.
Section 43.8 âCore Power Supply POR Characteristicsâ, added to datasheet.
Table 43-25, âEmbedded Flash Wait Statesâ FWS rows 5, 6 removed, Read Operations column removed,
values assigned to Max MCK Frequency columns
Table 43-17, âPLLA Characteristics(1)â FOUT Min &M ax updated
Table 43-9, âXIN Clock Electrical Characteristicsâ, line added for VIN.
Section 43.4 âClock Characteristicsâ, Section 43.12 âSMC Timingsâ, Section 43.13 âSDRAMCâ,
Section 43.14 âEMAC Timingsâ, Section 43.15 âPeripheral Timingsâ, added to datasheet.
Table 43-21, âAnalog Inputsâ, ADC input capacitance is 12 pF TYP, 14 pF MAX.
Mechanical Characteristics:
Table 44-1, âSoldering Information (Substrate Level),â on page 841, updated title.
5335
5345
5789
5562
5800
5298 &
5923/6189
5924
6049
6167
rfo
6242
5288
Errata:
Section 46.2 âAT91SAM9XE128/256/512 Errata - Revision A partsâ
Former Errata - Revision B parts replaced and become Errata - Revision A parts. Former Errata - Revision A
parts removed from Errata
5922
Section 46.2.2.2 âMCI: SDIO Interrupt does not work with slots other than Aâ, syntax updated.
Section 46.2.6.1 âSSC: Clock is Transmitted before the SSC is Enabledâ, added to SSC errata.
Section 46.2.5.2 âSPI: Bad Serial Clock Generation on second chip_select when SCBR = 1, CPOL = 1 and
NCPHA = 0â, added to SPI errata.
Section 46.2.5.3 âSPI: Software Reset must be Written Twiceâ, added to SPI errata.
Section 46.2.3 âReset Controller (RSTC)â, added to errata.
Section 46.2.3.2 âRSTC: Reset During SDRAM Accessesâ, added to errata.
Section 46.2.4 âStatic Memory Controller (SMC)â added to errata.
6169
5439
rfo
5958
5925
6085
5642
854 AT91SAM9XE128/256/512 Preliminary
6254BâATARMâ29-Apr-09
|
▷ |