PS-AT17LV010 Datasheet, PDF (5/15 Pages) ATMEL Corporation – MICROCIRCUIT, MEMORY, DIGITAL, CMOS, 1 MEGABIT SERIAL EEPROM, MONOLITHIC SILICON

PS-AT17LV010
Rev A
2 APPLICABLE DOCUMENTS
MIL-PRF-38535 ........................................Integrated Circuits, Manufacturing, General Specification for.
MIL-STD-883 ............................................Test Method Standard Microcircuits.
ASTM Standard F1192-95 ........................Standard guide for the measurement of single event phenomena
from heavy ion irradiation of semiconductor devices
JEDEC Standard EIA/JESD78..................IC latch-up test
ATMEL Aerospace Products Quality Flows
In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence.
3 REQUIREMENTS
3.1 Design, construction, and physical dimensions.
The design, construction, and physical dimensions shall be as specified in MIL-PRF-38535 and
herein.
3.1.1
Package type.
The package shall be a flat pack 400 mils, 28 leads (figure1). The case shall be hermetically
sealed and have a ceramic body. The leads shall be brazed.
3.1.2
Terminal connections.
The terminal connections shall be as specified on figure 2 .
3.1.3
Block diagram.
The block diagram shall be as specified on figure 3 .
3.1.4
Timing waveforms.
The timing waveforms shall be as specified on figure 4.
3.2 Marking
Each component shall be marked in respect of :
(a) Lead Identification
(b) Component Number
(c) Traceability Information
(d) Manufacturer’s Component Number
3.2.1
Lead Identification
An index shall be located at the top of the package in the position defined in Figure 1.
3.2.2
Component Number
Each component shall bear the component number which shall be constituted and marked as
follows :
AT17LV010-10DP-XX
Product identification
Speed (10 = 100 ns)
Package (DP = flat pack 28)
Level (MQ=Military Level B – SV=Space Level B)
Sheet 5 / 15