AT24C04B_09 Datasheet, PDF (24/28 Pages) ATMEL Corporation – Two-wire Serial EEPROM

8Y6 – Mini Map
Figure 18. 8Y6 – Mini Map
Pin 1
Index
Area
A
D2
b
(8X)
Pin 1 ID
L (8X)
D
e (6X)
A2
A1
1.50 REF.
A3
COMMON DIMENSIONS
(Unit of Measure = mm)
SYMBOL
D
E
D2
E2
A
A1
A2
A3
L
e
b
MIN
1.40
-
-
0.0
-
0.20
0.20
NOM
2.00 BSC
3.00 BSC
1.50
-
-
0.02
-
0.20 REF
0.30
0.50 BSC
0.25
MAX
1.60
1.40
0.60
0.05
0.55
0.40
0.30
NOTE
2
Notes:
1. This drawing is for general information only. Refer to JEDEC Drawing MO-229, for proper dimensions,
tolerances, datums, etc.
2. Dimension b applies to metallized terminal and is measured between 0.15 mm and 0.30 mm from the terminal tip. If the
terminal has the optional radius on the other end of the terminal, the dimension should not be measured in thatradius area.
3. Soldering the large thermal pad is optional, but not recommended. No electrical connection is accomplished to the
device through this pad, so if soldered it should be tied toground
10/16/07
TITLE
DRAWING NO. REV.
2325 Orchard Parkway _{8Y6, 8-lead 2.0 x 3.0 mm Body, 0.50 mm Pitch, Utlra Thin Mini-Map,}
R San Jose, CA 95131 _{Dual No Lead Package (DFN) ,(MLP 2x3)}
8Y6
D
24 AT24C04B/08B
5226G–SEEPR–11/09