AT24C04B_09 Datasheet, PDF (21/28 Pages) ATMEL Corporation – Two-wire Serial EEPROM

12. Packaging Information
8P3 – PDIP
Figure 15. 8P3 – PDIP
1
Two-wire Serial EEPROM
E
E1
N
Top View
c
eA
End View
D
e
D1
A2 A
b3
4 PLCS
b2
L
b
Side View
COMMON DIMENSIONS
(Unit of Measure = inches)
SYMBOL
A
A2
b
b2
b3
c
D
D1
E
E1
e
eA
L
MIN NOM MAX
–
–
0.210
0.115 0.130 0.195
0.014 0.018 0.022
0.045 0.060 0.070
0.030 0.039 0.045
0.008 0.010 0.014
0.355 0.365 0.400
0.005
–
–
0.300 0.310 0.325
0.240 0.250 0.280
0.100 BSC
0.300 BSC
0.115 0.130 0.150
NOTE
2
5
6
6
3
3
4
3
4
2
Notes:
1. This drawing is for general information only; refer to JEDEC Drawing MS-001, Variation BA, for additional information.
2. Dimensions A and L are measured with the package seated in JEDEC seating plane Gauge GS-3.
3. D, D1 and E1 dimensions do not include mold Flash or prortusions. Mold Flash or protrusions shall not exceed 0.010 inch.
4. E and eA measured with the leads consrtained to be perpendicular to datum.
5. Pointed or rounded lead tips are preferred to ease insertion.
6. b2 and b3 maximum dimensions do not include Dambar protrusions. Dambar protrusions shall not exceed 0.010 (0.25 mm).
01/09/02
2325 Orchard Parkway
R San Jose, CA 95131
TITLE
8P3, 8-lead, 0.300" Wide Body, Plastic Dual
In-line Package (PDIP)
DRAWING NO. REV.
8P3
B
5226G–SEEPR–11/09
21