AT91SAM9261S_1 Datasheet, PDF (188/709 Pages) ATMEL Corporation – AT91 ARM Thumb-based Microcontrollers

AT91SAM9261S
22.11.3
Ready Mode
In Ready mode (EXNW_MODE = 11), the SMC behaves differently. Normally, the SMC begins
the access by down counting the setup and pulse counters of the read/write controlling signal. In
the last cycle of the pulse phase, the resynchronized NWAIT signal is examined.
If asserted, the SMC suspends the access as shown in Figure 22-28 and Figure 22-29. After
deassertion, the access is completed: the hold step of the access is performed.
This mode must be selected when the external device uses deassertion of the NWAIT signal to
indicate its ability to complete the read or write operation.
If the NWAIT signal is deasserted before the end of the pulse, or asserted after the end of the
pulse of the controlling read/write signal, it has no impact on the access length as shown in Fig-
ure 22-29.
Figure 22-28. NWAIT Assertion in Write Access: Ready Mode (EXNW_MODE = 11)
MCK
A[25:2]
NBS0, NBS1,
NBS2, NBS3,
A0,A1
Wait STATE
NWE
4
3
2
1
0
0
0
6
5
4
3
NCS
2
1
1
1
0
D[31:0]
NWAIT
internally synchronized
NWAIT signal
Write cycle
EXNW_MODE = 11 (Ready mode)
WRITE_MODE = 1 (NWE_controlled)
NWE_PULSE = 5
NCS_WR_PULSE = 7
6242E–ATARM–11-Sep09
188