|
ATR2731 Datasheet, PDF (1/26 Pages) ATMEL Corporation – DAB One-chip Front End | |||
|
Features
⢠8.5V Supply Voltage
⢠Voltage Regulator for Stable Operating Conditions
⢠Microprocessor-controlled Via a Simple Two-wire Bus
⢠Two Selectable Addresses
⢠Gain-controlled RF Amplifier with Two Inputs, Selectable Via a Simple Two-wire Bus
Control
⢠Balanced RF Amplifier Inputs
⢠Gain-controlled RF Mixer
⢠Four-pin Voltage-controlled Oscillator
⢠SAW Filter Driver With Differential Low-impedance Output
⢠AGC Voltage Generation for RF Section, Available at Charge-pump Output (Can Also
Be Used to Control a PIN Diode Attenuator)
⢠Gain-controlled IF Amplifier
⢠Balanced IF Amplifier Inputs
⢠Selectable Gain-controlled IF Mixer
⢠Single-ended IF Output
⢠AGC Voltage Generation for IF Section, Available at Charge-pump Output
⢠Separate Differential Input for the IF AGC Block
⢠All AGC Time Constants are Adjustable
⢠AGC Thresholds Programmable Via a Simple Two-wire Bus
⢠Three AGC Charge Pump Currents Selectable (Zero, Low, High)
⢠Reference Oscillator
⢠Programmable 9-bit Reference Divider
⢠Programmable 15-bit Counter 1:2048 to 1:32767 Effectively
⢠Tri-state Phase Detector with Programmable Charge Pump
⢠Superior Phase-noise Performance
⢠Programmable Deactivation of Tuning Output
⢠Three Switching Outputs (Open Collector)
⢠Three D/A Converters (Resolution: 8 Bits)
⢠Lock Status Indication (Open Collector)
DAB One-chip
Front End
ATR2731
Rev. 4904AâDABâ03/06
|
▷ |