AMIS-710616 Datasheet, PDF (6/19 Pages) AMI SEMICONDUCTOR – CIS PCB

AMIS-710616-AS: CIS PCB
Product Specification
Data Sheet
9.2 Amplifier Board Output Connectors, ERNI594083
There are four connectors on the amplifier board. Two are inputs, which are described above, and two are outputs, which are described
below. There is only one table shown for both connectors. They are both identical in their connections except that one is for the outputs
of Sensor Board 1 and the other is for the outputs of Sensor Board 2. Accordingly, each of the video outputs after amplification for both
sensor boards are labeled, VOUT1, VOUT2, VOUT3 and VOUT4. Videos from Sensor Board 1, VSEC1’s corresponding output is
VOUT1, VSEC2’s corresponding output is VOUT2, VSEC3’s corresponding output is VOUT3 and VSEC4’s corresponding output is
VOUT4. Then the videos from Sensor Board 2 will have their corresponding outputs on the second connector VOUT1, VOUT2, VOUT3
and VOUT4, except their outputs VOUT5, VOUT6, VOUT7 and VOUT8 because those video signals originate from Section 5, Section
6, Section 7 and Section 8 of Sensor Board 2.
Table 9-2: Amplifier Board Output Connectors, ERNI-594083
Pin Numbers
Description Row A
Description Row B
Description Row C
1
VDD
VDD
AGND
2
VDD
VDD
VOUT1
3
No connect
No connect
AGND
4
Ground
Ground
AGND
5
SP
GND
AGND
6
No connect
GND
VOUT2
7
No connect
GND
AGND
8
No connect
GND
AGND
9
CLK
GND
AGND
10
GND
GND
VOUT3
11
No connect
GND
AGND
12
No connect
GND
AGND
13
No connect
GND
AGND
14
GND
GND
VOUT4
15
No connect
No connect
AGND
16
VSS
VSS
AGND
Note: The functional description for the symbols used in Table 9-2 are the same as described for the input connector. The two new symbols VSS and CLK are as follows:
VSS is negative supply input. CLK is CP.
The locations of Pin 1 on all the connectors are facing the same end (see Figure 2).
AMI Semiconductor – July 06, M-20595-001
6
www.amis.com