EPM9560RC240-15 Datasheet, PDF (29/46 Pages) Altera Corporation – Programmable Logic Device Family

MAX 9000 Programmable Logic Device Family Data Sheet
Table 20. MAX 9000A Device Typical I_CC Supply Current Values
Symbol
Parameter
Conditions
EPM9320A EPM9560A Unit
I _CC1
I_CC supply current (low-power mode, V_I = ground, no load (11)
standby, typical)
99
174
mA
Notes to tables:
(1) See the Operating Requirements for Altera Devices Data Sheet.
(2) Minimum DC input on I/O pins is –0.5 V and on the four dedicated input pins is –0.3 V. During transitions, the
inputs may undershoot to –2.0 V or overshoot to 7.0 V for periods shorter than 20 ns under no-load conditions.
(3) V_CC must rise monotonically.
(4) Numbers in parentheses are for industrial-temperature-range devices.
(5) Typical values are for T _A = 25° C and V_CC = 5.0 V.
(6) These values are specified under the MAX 9000 recommended operating conditions, shown in Table 15 on page 27.
(7) During in-system programming, the minimum V_IH of the JTAG TCK pin is 3.6 V. The minimum V_IH of this pin
during JTAG testing remains at 2.0 V. To attain this 3.6-V V_IH during programming, the ByteBlaster and
ByteBlasterMV download cables must have a 5.0-V V_CC.
(8) This parameter is measured with 50% of the outputs each sinking 12 mA. The I_OH parameter refers to high-level
TTL or CMOS output current; the I_OL parameter refers to the low-level TTL or CMOS output current.
(9) JTAG pin input leakage is typically –60 µΑ.
(10) Capacitance is sample-tested only and is measured at 25° C.
(11) Measured with a 16-bit loadable, enabled, up/down counter programmed into each LAB. I_CC is measured at 0° C.
Figure 13 shows typical output drive characteristics for MAX 9000 devices
with 5.0-V and 3.3-V V_CCIO.
Figure 13. Output Drive Characteristics of MAX 9000 Devices Note (1)
5.0-V
150
I_OL
3.3-V
150
I_OL
120
120
Typical I_{O 90}
Output
Current (mA)
60
30
V_CCIO = 5.0 V
Room Temperature
I_OH
Typical I_O 90
Output
Current (mA)
60
30
V_CCIO = 3.3 V
Room Temperature
I_OH
1
2
3
4
5
Output Voltage (V)
Note:
(1) Output drive characteristics include the JTAG TDO pin.
1
2
3 ^3.3 4
5
Output Voltage (V)
Altera Corporation
29