AMG-PI004 Datasheet, PDF (19/20 Pages) alpha microelectronics gmbh – H-Bridge/Full Bridge Array of P and N channel MOSFETs

AMG-PI004
H-Bridge/Full Bridge Array of P and N channel MOSFETs
13. IC-Marking
IC name = αPI004
Date code = YYWW
Lot number = XXYYZZ
14. Notes and Cautions
14.1. ESD Protection
The Requirements for Handling Electrostatic Discharge Sensitive Devices are described in the
JEDEC standard JESD625-A. Please note the following recommendations:
 When handling the device, operators must be grounded by wearing a for the purpose
designed grounded wrist strap with at least 1MΩ resistance and direct skin contact.
 Operators must at all times wear ESD protective shoes or the area should be
surrounded by for ESD protection intended floor mats.
 Opening of the protective ESD package that the device is delivered in must only occur at
a properly equipped ESD workbench. The tape with which the package is held together
must be cut with a sharp cutting tool, never pulled or ripped off.
 Any unnecessary contact with the device or any unprotected conductive points should be
avoided.
 Work only with qualified and grounded tools, measuring equipment, casing and
workbenches.
 Outside properly protected ESD-areas the device or any electronic assembly that it may
be part of should always be transported in EGB/ESD shielded packaging.
14.2. Storage conditions
The AMG-PI004 corresponds to moisture sensitivity classification ML2 , according to JEDEC
standard J-STD-020, and should be handled and stored according to J-STD-033.
AMG-PI004 Revision: B
06.11.12
© All rights reserved Page 19 of 20