AKD4569 Datasheet, PDF (8/27 Pages) Asahi Kasei Microsystems – Evaluation board Rev.A for AK4569

ASAHI KASEI
[AKD4569]
AKD4116 Control Program operation manual
n Set-up of evaluation board and control software
1. Set up the AKD4569 according to above mentioned setting.
2. Connect IBM-AT compatible PC with AKD4569 by 10-line type flat cable (packed with AKD4569). Take care of
the direction of 10pin header. (Please install the driver in the floppy-disk when this control software is used on
Windows 2000/XP. Please refer “Installation Manual of Control Software Driver by AKM device control software”.
In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows
NT.)
3. Insert the CD-ROM labeled “AK4569 Evaluation Kit” into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of “akd4116_1.exe” and “akd4116_2.exe” to set up the control
program.
5. Then please evaluate according to the follows.
n Operation flow
Keep the following flow.
1. Set up the control program.
2. Click “Port Setup” button.
3. Then set up the dialog and input data.
n Explanation of each buttons
1. [Port Setup] : set up the printer port.
2. [Write default] : initialize the register of AK4116.
3. [All read] : read all registers.
4. [Read] : read data from each register.
5. [Write] : write data to each register.
If you want to write the input data to AK4116, click “OK” button. If not, click “Cancel” button.
n Indication of data
Input data is indicated on the register map. Red letter indicates “H” or “1” and blue one indicates “L” or “0”. Blank is the
part that is not defined in the datasheet.
End.
<KM074000>
-8-
2004/02