AK4183_06 Datasheet, PDF (8/17 Pages) –

ASAHI KASEI
[AK4183]
„ Digital I/F
The AK4183 operates with uP via I²C bus and supports the standard mode (100 KHz) and the fast mode (400KHz). Note that the
AK4183 operates in those two modes and does not support a High speed mode I²C-bus system (3.4MHz). The AK4183 can operate
as the slave device on the I²C bus network.
VCC=2.5V – 3.6V
Micro-
Rp
Rp
Processor
I²C bus
controller
SCL
SDA
PENIRQN
VCC
AK4183
CAD0
“L” or “H”
Figure 4 Digital I/F
[Start condition and Stop condition]
A HIGH to LOW transition on the SDA line while SCL is HIGH indicates a START condition. All sequences start by the START
condition or Repeated Start Condition. Repeated Start condition is the same signal tradition as Start condition.
A LOW to HIGH transition on the SDA line while SCL is HIGH defines a STOP condition. All sequences are terminated by the
STOP or Repeated Start condition. Repeated Start is also the Start condition of next transfer so that I2C bus cannot be idle.
SDA
SCL
S/Sr
S : Start condition
Sr : Repeated start condition
P : stop condition
Figure 5 START and STOP Conditions
[Data transfer]
All commands are preceded by a START condition. After the START condition, a slave address is sent. After the AK4183
recognizes the START condition, the device interfaced to the bus waits for the slave address to be transmitted over the SDA line. If
the transmitted slave address matches an address for one of the devices, the designated slave device pulls the SDA line to LOW
(ACKNOWLEDGE). The data transfer is always terminated by a STOP condition generated by the master device.
MS0500-E-00
8
2006/04