AK4183_06 Datasheet, PDF (2/17 Pages) –

ASAHI KASEI
„ Ordering Guide
AK4183VT
-40°C ∼ +85°C
10pin TMSOP (0.5mm pitch)
„ Pin Layout
VCC 1
XP 2
YP 3
XN 4
YN 5
Top View
10 SCL
9 _SDA
8 CAD0
7 ^PENIRQN
6 ^GND
[AK4183]
No.
Signal Name
1 VCC
2 XP
3 YP
4 XN
5 YN
6 GND
7 PENIRQN
8 CAD0
9 SDA
10 SCL
Pin/Function
I/O
Description
- Power Supply
I/O Touch Screen X+ plate Voltage supply
„ X axis Measurement: Supplies the voltage to X+ position input of the touch panel.
„ Y axis Measurement: This pin is used as the input for the A/D converter
„ Pen Pressure Measurement: This pin is the input for the A/D converter at Z1 measurement.
„ Pen Waiting State: Pulled up by an internal resistor (typ.10K ohm).
I/O Touch Screen Y+ plate Voltage supply
„ X axis Measurement: This pin is used as the input for the A/D converter
„ Y axis Measurement: Supplies the voltage to Y+ position input of the touch panel
„ Pen Pressure Measurement: Supplies the voltage to Y+ position input of the touch panel.
„ Pen Waiting State: OPEN state
I/O Touch Screen X- plate Voltage supply
„ X axis Measurement: Supplies the voltage to X- position input of the touch panel
„ Y axis Measurement: OPEN state
„ Pen Pressure Measurement: Supplies the voltage to X- position input of the touch panel
„ Pen Waiting State: OPEN state
I/O Touch Screen Y- plate Voltage supply
„ X axis Measurement: OPEN state
„ Y axis Measurement: Supplies the voltage to Y- position input of the touch panel
„ Pen Pressure Measurement: This pin is the input for the A/D converter at Z2 measurement.
„ Pen Waiting State: connected to GND.
- Ground
O Pen Interrupt Output
This pin is “L” during the pen down on pen interrupt enabled state otherwise this pin is “H”.
This pin is “L” during pen interrupt disabled state regardless pen touch.
I I²C bus Slave Address bit 0
I/O I²C serial data
I I²C serial clock
MS0500-E-00
2
2006/04