AK4385 Datasheet, PDF (16/21 Pages) Asahi Kasei Microsystems – 108dB 192kHz 24-Bit 2ch ΔΣ DAC

ASAHI KASEI
[AK4385]
„ Mode Control Interface
Internal registers may be written by 3-wire µP interface pins, CSN, CCLK and CDTI. The data on this interface consists
of Chip Address (2bits, C1/0; fixed to “01”), Read/Write (1bit; fixed to “1”, Write only), Register Address (MSB first,
5bits) and Control Data (MSB first, 8bits). AK4385 latches the data on the rising edge of CCLK, so data should clocked
in on the falling edge. The writing of data becomes valid by CSN “↑”. The clock speed of CCLK is 5MHz (max).
PDN = “L” resets the registers to their default values. The internal timing circuit is reset by RSTN bit, but the registers are
not initialized.
CSN
CCLK
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
CDTI
C1 C0 R/W A4 A3 A2 A1 A0 D7 D6 D5 D4 D3 D2 D1 D0
C1-C0:
R/W:
A4-A0:
D7-D0:
Chip Address (Fixed to “01”)
READ/WRITE (Fixed to “1”, Write only)
Register Address
Control Data
Figure 8. Control I/F Timing
*AK4385 does not support the read command and chip address. C1/0 and R/W are fixed to “011”
*When the AK4385 is in the power down mode (PDN = “L”) or the MCLK is not provided, writing into the control
register is inhibited.
„ Register Map
Addr Register Name
D7
D6
D5
D4
D3
D2
D1
D0
00H Control 1
ACKS
0
0
DIF2
DIF1 DIF0
PW
RSTN
01H Control 2
02H Control 3
03H Lch ATT
04H Rch ATT
DZFE
0
ATT7
ATT7
DZFM
0
ATT6
ATT6
SLOW
0
ATT5
ATT5
DFS1
0
ATT4
ATT4
DFS0
0
ATT3
ATT3
DEM1
DZFB
ATT2
ATT2
DEM0
0
ATT1
ATT1
SMUTE
0
ATT0
ATT0
Notes:
For addresses from 05H to 1FH, data must not be written.
When PDN pin goes “L”, the registers are initialized to their default values.
When RSTN bit goes “0”, the only internal timing is reset and the registers are not initialized to their default
values.
All data can be written to the register even if PW or RSTN bit is “0”.
MS0246-E-00
- 16 -
2003/07