SW06 Datasheet, PDF (8/12 Pages) Analog Devices – Quad SPST JFET Analog Switch

SW06–Typical Performance Characteristics (Operating and Single Supply)
“On” Resistance vs. Analog Voltage
Leakage Current vs. V_ANALOG
Supply Current vs. Supply Voltage
Switching Time vs. Supply Voltage
NOTE
These single-supply-operation characteristic curves are valid
when the negative power supply V– is tied to the logic ground
reference pin “GND.” TTL input compatibility is still main-
tained when “GND” is the same potential as the TTL ground.
t_OFF is measured from 50% of logic input waveform to 0.9 V_O.
The analog voltage range extends from 0 V to V+ –4 V; the
switch will no longer respond to logic control when V_A is within
4 volts of V+.
Simplified Schematic Diagram (Typical Switch)
–8–
REV. A